[Docs] [txt|pdf|xml|html] [Tracker] [Email] [Diff1] [Diff2] [Nits]

Versions: 00 01

Internet Engineering Task Force                            J. Lemon, Ed.
Internet-Draft                                                  Broadcom
Intended status: Standards Track                                M. Smith
Expires: September 3, 2018                                         Cisco
                                                           March 2, 2018


              Geneve encapsulation for Group Based Policy
                       draft-lemon-geneve-gbp-01

Abstract

   This document describes how a Group Policy Identifier is encapsulated
   in Geneve for the purposes of policy enforcement.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at https://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on September 3, 2018.

Copyright Notice

   Copyright (c) 2018 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (https://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.





Lemon & Smith           Expires September 3, 2018               [Page 1]


Internet-Draft          GBP Geneve Encapsulation              March 2018


Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
   2.  Conventions . . . . . . . . . . . . . . . . . . . . . . . . .   2
     2.1.  Requirement Language  . . . . . . . . . . . . . . . . . .   2
     2.2.  Abbreviations . . . . . . . . . . . . . . . . . . . . . .   2
   3.  Group Based Policy Encapsulation in Geneve  . . . . . . . . .   2
   4.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   4
   5.  Security Considerations . . . . . . . . . . . . . . . . . . .   4
   6.  Normative References  . . . . . . . . . . . . . . . . . . . .   4
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .   5

1.  Introduction

   This document defines the group-based policy (GBP) encapsulation for
   Geneve [I-D.ietf-nvo3-geneve].  The GBP sub-header carries a 16-bit
   group policy ID that is semantically equivalent to the 16-bit group
   policy ID defined in [I-D.smith-vxlan-group-policy].

2.  Conventions

2.1.  Requirement Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

2.2.  Abbreviations

   Abbreviations used in this document:

   GBP:       Group-Based Policy

   Geneve:    Generic Network Virtualization Encapsulation

3.  Group Based Policy Encapsulation in Geneve

   For encapsulating group policy IDs into Geneve [I-D.ietf-nvo3-geneve]
   the group policy ID field is included in the Geneve header using
   tunnel options.  The group policy ID field uses a tunnel option class
   specific for GBP.  In an administrative domain where GBP is used,
   insertion of the GBP tunnel option in Geneve is enabled at the Geneve
   tunnel endpoints.  The Geneve header is defined in
   [I-D.ietf-nvo3-geneve].  GBP semantics are described in
   [I-D.smith-vxlan-group-policy].

   The packet format of the GBP ID when encapsulated in Geneve is
   defined below.



Lemon & Smith           Expires September 3, 2018               [Page 2]


Internet-Draft          GBP Geneve Encapsulation              March 2018


    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+--+
   |Ver|  Opt Len  |O|C|    Rsvd.  |          Protocol Type        |  |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Hdr
   |        Virtual Network Identifier (VNI)       |    Reserved   |  |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+--+
   |  Option Class = GBP           |  Type         |R|R|R| Length  |  |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ GBP
   |            GBP ID             |A|D|    Reserved               | ID
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+<-+

          Figure 1: Group Based Policy as a Geneve Tunnel Option

   The GBP header consists of 8 octets, as illustrated in Figure 1.  The
   first 4 octets are the Geneve Tunnel Option header
   [I-D.ietf-nvo3-geneve], whose format is as follows:

   Option Class:  16-bit unsigned integer that determines the GBP option
      class.  The value is from the IANA registry setup for Geneve
      option classes as defined in [I-D.ietf-nvo3-geneve].

   Type:  8-bit unsigned integer defining the GBP ID type.  Two values
      are defined:

      GBP_Source_ID:  The Group Policy ID associated with the source of
         the packet.

      GBP_Destination_ID:  The Group Policy ID associated with the end
         destination of the packet.

      Note that if the packet carries a GBP_Destination_ID, it MUST also
      carry a GBP_Source_ID.

   R (3 bits):  Option control flags reserved for future use.  MUST be
      zero on transmission and ignored on receipt.

   Length:  5-bit unsigned integer.  Length of the GBP HDR in 4-octet
      units.

   The next 4 octets are the GBP header, whose format is as follows:

   Group Policy ID:  16-bit group policy identifier as as defined in
      [I-D.smith-vxlan-group-policy].

   Policy Applied bit (A bit):  The A bit is set to 0 to indicate that
      the group policy has not (yet) been applied to this packet.  Group
      policies MUST be applied by devices when the A bit is set to 0 and



Lemon & Smith           Expires September 3, 2018               [Page 3]


Internet-Draft          GBP Geneve Encapsulation              March 2018


      the destination group has been determined.  Devices that apply the
      group policy MUST set the A bit to 1 after the policy has been
      applied.  The A bit is set to 1 to indicate that the group policy
      has already been applied to this packet.  Policies that redirect
      the packet MUST NOT be applied by devices when the A bit is set.
      Policies that cause the packet to be dropped MAY be applied.

   Don't Learn bit (D bit):  The D bit is set to 1 to indicate that the
      tunnel endpoint MUST NOT learn the source address of the
      encapsulated frame.

   Reserved (14 bits):  reserved for future use.  MUST be zero on
      transmission and ignored on receipt.

4.  IANA Considerations

   IANA is requested to allocate a Geneve "option class" number for GBP:

                 +---------------+-------------+---------------+
                 | Option Class  | Description | Reference     |
                 +---------------+-------------+---------------+
                 | x             | GBP_ID      | This document |
                 +---------------+-------------+---------------+

5.  Security Considerations

   The security considerations of Geneve are discussed in
   [I-D.ietf-nvo3-geneve].  The security considerations of GBP are
   discussed in [I-D.smith-vxlan-group-policy].

   Additionally, the security policy value carried in the GBP header
   impacts security directly.  There is a risk that this identifier
   could be altered.  Accordingly, the network should be designed such
   that this header can be inserted only by trusted entities, and can
   not be altered before reaching the destination.  This can be
   mitigated through physical security of the network and/or by
   encryption or validation of the entire packet, including the GBP.

6.  Normative References

   [I-D.ietf-nvo3-geneve]
              Gross, J., Ganga, I., and T. Sridhar, "Geneve: Generic
              Network Virtualization Encapsulation", draft-ietf-
              nvo3-geneve-05 (work in progress), September 2017.







Lemon & Smith           Expires September 3, 2018               [Page 4]


Internet-Draft          GBP Geneve Encapsulation              March 2018


   [I-D.smith-vxlan-group-policy]
              Smith, M. and L. Kreeger, "VXLAN Group Policy Option",
              draft-smith-vxlan-group-policy-04 (work in progress),
              October 2017.

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <https://www.rfc-editor.org/info/rfc2119>.

Authors' Addresses

   John Lemon (editor)
   Broadcom Limited
   270 Innovation Drive
   San Jose, CA  95134
   USA

   Email: john.lemon@broadcom.com


   Michael Smith
   Cisco Systems

   Email: michsmit@cisco.com


























Lemon & Smith           Expires September 3, 2018               [Page 5]


Html markup produced by rfcmarkup 1.126, available from https://tools.ietf.org/tools/rfcmarkup/